Skip to content
Still need help? Customer portal
  • There are no suggestions because the search field is empty.

Mini Ryzer Assembly Guide

The Mini Ryzer assembles differently from the Solo and Prime Ryzer due to its single-motor design and compact crossbeam. This guide covers the key steps and what to watch for on smaller setups.

How the Mini Ryzer Assembly Differs

The Mini Ryzer has one motor column (center-mounted) rather than two independent leg columns. The crossbeam design is also more compact. The basic process — attach legs, attach crossbeam, mount tabletop, connect cables, initialize — is the same, but the physical steps differ slightly.

Assembly Steps

1. Unbox and identify parts

Lay out both leg feet, the center motor column, crossbeam arms, control box, handset, hardware bag, and any included accessories. Verify against the packing list.
 

2. Attach crossbeam arms to the motor column

Slide the left and right crossbeam arms into the motor column bracket. Adjust to your tabletop width and tighten the bracket bolts.
 

3. Attach leg feet

Attach the T-shaped leg feet to the ends of each crossbeam arm using the provided bolts. These provide the floor contact points and levelling feet.
 

4. Mount the tabletop (face-down method)

Place the tabletop face-down on a blanket. Set the frame on top, center it, and drive the mounting screws through the crossbeam holes into the tabletop.
 

5. Connect handset to control box

The Mini Ryzer control box is integrated with the motor column. Plug the handset cable into the HS port on the column.
 

6. Flip upright, plug in, and initialize

Flip the desk upright, plug in the power cord, and run the RST initialization: hold DOWN until the desk fully lowers. The Mini Ryzer is now ready.

 

Small-Space Setup Tips

  • The Mini Ryzer's footprint is narrower — you have less lateral stability than a two-leg desk; place it against a wall or in a corner for added stability if needed
  • Avoid placing very heavy items on one side of the tabletop — the single-column design is more sensitive to off-center loads than two-leg models
  • Cable management is simpler on the Mini — a single cable spine along the center column keeps things tidy